MEDUSA4 on Windows Platform
3 posts • Page 1 of 1
Hi there, I am doing some TurboCAD 2D / 3D tutorials on Medusa4 Personal. In the screenshot I am trying to remove the bottom line section on the two boxes. I started with a rectangle, used offset construction lines and the line tool to make the two boxes. I know I could have used Smart Drafting, but wanted to learn the basic method to compare with my experience with TurboCAD. With TurboCAD you would use Object Trim to delete the lower lines, so you end up with two wide, open notches. The line segment below the the drawing is what I am trying to do. But I noticed that the Standard Edit Line Tools are greyed out, except for Trim/extends, Fillet Lines, Move Segments and Chamfer Lines tools. Have Medusa4 Personal 5.2.1.
- TurboCAD Tutorial.png (3.17 KiB) Viewed 20360 times