Little configuration tool!

jutotu · Post by **jutotu** » Wed May 28, 2003 5:32 am

Hello Medusers

I want to write a little tool to configurate my drawings, i.e. to make layer visible/invisible, write material-number, etc. This should be made through a form-window to facilitate the handling for our vendors. How can I do it with Medusa 2000i2 (still tablets-user-interface)? Which posibilities do I have to comunicate with the program without Bacis, i.e VBA, C, FORTRAN? (that's because I don't know how to program with Bacis, how can I find info about it?) Thanks a lot for your help,

Jutotu

TimothyGoorn · Post by **TimothyGoorn** » Sat Mar 09, 2019 8:26 pm

Probably a small miracle but looking for the FS-CT Configuration Tool for Siemens FS-100 Panel.

Thanks Doug