Page 1 of 1

Medusa Personal and CAM - originally by wrench

Posted: Thu Jun 20, 2013 6:36 pm
by admin
I am an amateur machinist but this hobby has grown to include many different types of CNC machines. As such, some sort of CAM support is mandatory before I even consider downloading an application....

Therefore, is there any way to get Medusa to integrate with one of the low cost CAM systems that are out there? If not, Medusa is a non-starter, unfortunately.

Medusa Personal and CAM originally by wrench

Posted: Thu Jan 31, 2019 4:34 pm
by TimothyGoorn
also I have found that toptool does not load :/ this maybe the problem is there a fix?

Medusa Personal and CAM originally by wrench

Posted: Wed Mar 13, 2019 12:20 pm
by HenryNEs
I can try but I doubt that the problem is the GPU. Is Debian 10 going to support skylake and coffee lake?